Lenze ECSCPxxx - Manual (Page 242)

Commissioning
Controller enable (CINH = 0)
6
l
242 EDBCSXP064 EN 8.0
The following table describes the status displays for the controller inhibit (Cinh) /
controller enable:
Status display Controller inhibited Enable controller Comment
Green LED Blinking Constantly ON
C0183 drive
diagnostics Display of the signal
source for controller
inhibit (Cinh) Display "OK" See GDC menu "Diagnostics / Device
current status" or GDC monitor window
down right
C0150 DCTRL status
word Bit 7 (CINH
active) C0150.Bit07 = 1 C0150.Bit07 = 0 See GDC menu "Diagnostics / display
MCTRL"
Keypad text display
"IMP" "IMP" "IMP" not displayed
)
Note!
All signal sources for controller inhibit (Cinh) act like a series connection of
switches which are independent of each other.