Lenze ECSCPxxx - Manual (Page 453)

Index 13
l
453 EDBCSXP064 EN 8.0
Sync identifiers, 280
Sync phase displacement, 278
− correction value, 279
Sync signal source, 278
Sync telegram, 421
Synchronisation
− CAN sync response, 281
− cyclic process data objects, 421
Synchronisation cycle, 278
Synchronisation via CAN, 282
Synchronisation via terminal X6/DI1, 283
System bus (CAN), 411 , 412
− assignment of the plug connectors, 81
− baud rate, 83 , 84
− communication, 412
− configuring, 266
− cyclic process data objects, synchronisation, 421
− determining the master in the drive system, 273
− event−controlled process data objects, 422
− identifier, 412 , 429
− individual addressing, 271
− network management data, 413
− parameter data, 413 , 423
− parameter data channels, 423
− process data, 413
− process data objects, 417
addressing, 429
data transmission, 419
− process data telegrams, 418
− setting delay time, 274
− setting the baud rate, 266
− setting the cycle time, 274
− setting the node address, 266
− user data, 413 , 424
− wiring, 80 , 82
system bus (CAN)
− CAN data telegram, 412
− parameter data objects, addressing, 429
System bus components, 432
System error messages, Causes and remedies, 343
T
Target position, 97
− setting the target position window, 229
Target position selection, maximum, 106
Technical data, 30
− current characteristics
application example, 36
device protection by current derating, 37
rated output current, 34
− external brake resistor
type ERBD..., 433
type ERBM..., 433
type ERBS..., 434
− general electrical data, 31
− rated data, 32 , 33
− standards and operating conditions, 30
Telegram counter CAN, 287
Temperature, 30
Temperature inside the controller, monitoring functions,
304
Terminology used, 13
Thermal monitoring, motor, Sensorless, 22
Thermal sensors, monitoring functions, 305
Thermal separation, 41
Tightening torques
− Control connections, 54 , 67
− control connections, 52
Time−out monitoring for activated remote
parameterisation, 299
Timeout with activated remote parameterisation, CAN
interface, 299
Torque, safe torque off, 70
Torque limitation after positioning, 96
− activating, 208
Touch probe positioning, 93 , 194
− absolute TP positioning, 194
− relative touch probe positioning in the continuous
measuring system, 195
− relative with absolute reference, 195
Transmission cable, specification, 81
Traversing speed, 98
Traversing speed, maximum, 106
TRIP, 292
TRIP−RESET, 339 , 352
Trouble, 111