Lenze ECSCPxxx - Manual (Page 408)

Appendix
Code table
12
l
408 EDBCSXP064 EN 8.0
IMPORTANT Possible settings Code
Selection Lenze/
{Appl.} Designation No.
C4061 ES_ActN
Offset
Only for "electrical shaft"
function: Currently active value
of the angular trimming relating
to 15000 rev./min at current
speed.
Read only ^ 235
[C4062] ES_MCycle 0 Only for "electrical shaft"
function: Setpoint cycle of
master activates transmission of
master angle in the selected time
interval.
0 Off
1 2 ms
Value is written in C0369.
2 4 ms
3 6 ms
4 8 ms
5 10 ms
C4166 TripAppReset 0 Application fault message reset. ^ 338
0 Fault message active
1 Reset fault message
C4167 AppHistReset 0 Deleting application fault
message history buffer. ^ 338
0 No reaction
1 Delete history buffer
C4168 History buffer (list of application
faults occurred)
Read only ^ 338
^ 343
1 AppFailNo Current fault
2 AppFailNo Last
3 AppFailNo Last but one
4 AppFailNo Last but two
5 AppFailNo Last but three
All fault messages
(TRIP, KSB−TRIP, FAIL−QSP, warning, message)
C4169 Time when the application faults
entered into the history buffer
(C4168) occurred.
Read only ^ 338
1 FailTime Individual power−on times (C0179) Currently active fault
2 FailTime Last fault
3 FailTime Last but one fault
4 FailTime Last but two fault
0 {1 h} 65535
C4240 ActVal C3040 0.0 Internal value C3040
(limitation possible via C3030)
−214000.0000 {0.0001
units}
2140000.0000
C4241 ActVal C3041 0.0 Internal value C3041
(limitation possible via C3031)
−214000.0000 {0.0001
units}
2140000.0000