Lenze ECSCPxxx - Manual (Page 344)

Troubleshooting and fault elimination
Fault messages
Causes and remedies
11
l
344 EDBCSXP064 EN 8.0
Remedy Cause Description Fault message Remedy Cause Description
Display No.
0050 OH Heatsink temperature > +90 °C
Ambient temperature
T
u
> +40 °C or > +50 °C
l Allow module to cool and
ensure better ventilation.
l Check ambient temperature in
the control cabinet.
Heatsink is very dirty. Clean heatsink.
Wrong mounting position Change mounting position.
0051 OH1 Interior temperature > +90 °C
Ambient temperature
T
u
> +40 °C or > +50 °C
l Allow module to cool and
ensure better ventilation.
l Check ambient temperature in
the control cabinet.
Wrong mounting position Change mounting position.
x053 OH3 Motor temperature
> +150
°C threshold
(temperature detection via
resolver or incremental value
encoder)
Motor is thermally overloaded
due to:
l Impermissible continuous
current
l Frequent or too long
acceleration processes
l Check drive dimensioning.
l Switch off monitoring
(C0583 = 3).
No PTC/temperature contact
connected. Correct wiring.
x054 OH4 Heatsink temperature > C0122 Ambient temperature T
u
> +40 °C
or > +50 °C
l Allow module to cool and
ensure better ventilation.
l Check ambient temperature in
the control cabinet.
l Switch off monitoring
(C0582 = 3).
Heatsink is very dirty. Clean heatsink
Wrong mounting position Change mounting position.
The value specified under C0122
is set too low. Enter a higher value under C0122.
x055 OH5 Interior temperature > C0124 l Allow module to cool and
ensure better ventilation.
l Check ambient temperature in
the control cabinet.
l Switch off monitoring
(C0605 = 3).
The value under C0124 is set too
low. Enter a higher value under C0124.
x057 OH7 Motor temperature > C0121
(temperature detection via
resolver or incremental value
encoder) Motor is thermally overloaded
due to:
l Impermissible continuous
current
l Frequent or too long
acceleration processes
l Check drive dimensioning.
l Switch off monitoring
(C0584 = 3).
No PTC/temperature contact
connected. Correct wiring.
The value specified under C0121
is set too low. Enter a higher value in C0121.
x058 OH8 Motor temperature via inputs T1
and T2 is too high. Motor is thermally overloaded
due to:
l Impermissible continuous
current
l Frequent or too long
acceleration processes
l Check drive dimensioning.
l Switch off monitoring
(C0585 = 3).
Terminals T1 and T2 are not
connected Connect PTC/temperature
contact.
x: 0 = TRIP, 1 = Message, 2 = Warning, 3 = FAIL−QSP