Lenze ECSCPxxx - Manual (Page 368)

Appendix
Code table
12
l
368 EDBCSXP064 EN 8.0
IMPORTANT Possible settings Code
Selection Lenze/
{Appl.} Designation No.
C0202 Service code
Only display
1 Product code 1
... ...
4 Product code 4
C0203 Komm.−No. x / xxxx / xxxxx Commission number
Only display
C0204 Serial−No. Serial number
Read only
C0205 PLC Target ID Identification key
Only display
C0206 Product. date Production date
Only display
C0207 DL info 1 Download info 1
Only display
C0208 DL info 2 Download info 2
Only display
C0209 DL info 3 Download info 3
Only display
C0250 FCODE 1 Bit 0 Freely selectable digital signal
(1 bit)
0 1
C0254 Vp angle CTRL 0.4000 Phase controller gain (V
p
)
0.0000 { 0.0001} 3.9999
C0300 Service Codes Only the Lenze service is allowed
to make changes!
...
C0302
C0349 Status of the DIP switch for CAN
bus interface X4
Read only
1 CAN DIP−SW 0 {1} 63 Node address set on the DIP
switch
2 CAN DIP−SW 0 4 For setting the DIP switches > 4,
the display is set to 0.
C0350 CAN address 32 Node address for CAN bus
interface X4
l This code is not active if one
of the switches 2 ... 7 of the
DIP switch is set to "ON".
(
^ 266)
l After the setting process, a
reset node is required.
l A definite node address must
be assigned to each CAN
node.
^ 266
^ 429
1 {1} 63
C0351 CAN baud rate 0 Baud rate for CAN bus interface
X4
l The baud rate must be set
identically for all CAN nodes.
l This code is not active if one
of the switches 2 ... 7 of the
DIP switch is set to "ON".
l After the setting process, a
reset node is required.
^ 266
0 500 kbps
1 250 kbits/sec
2 125 kbit/s
3 50 kbps
4 1000 kbit/s