Lenze ECSCPxxx - Manual (Page 351)

Troubleshooting and fault elimination
Fault messages
Causes and remedies
11
l
351 EDBCSXP064 EN 8.0
Remedy Cause Description Fault message Remedy Cause Description
Display No.
3405 FollowErrFai
l Following error tolerance (C3030)
reached. The drive cannot follow the
setpoint. l Reduce acceleration.
l Increase the limit value C3030.
l Increase current limit C0022
(observe max. motor current).
l Check drive dimensioning.
3406 HomePosErr Home position has not been
reached.
Positioning profile mode in
C3095/x requires homing. Execute Homing or "Set
reference".
3409 MaxVelErr Max. speed in C1240 is set too
high. Maximum speed C1240 cannot be
reached due to the maximum
speed set in C0011. Reduce C1240 or increase C0011.
The highest possible value for
C1240 is displayed in C3060.
3417 InvSftwLimi
ts Impermissible setting of the
software limit positions Positive software limit position is
lower than the negative one
(C3040 < C3041). Correct the setting.
0425 InvHoming
Offs Reference measuring system
offset (C3012) is invalid. Entry of reference measuring
system offset (C3012) with
inverted motor−/encoder
mounting position (C3000 <>
C3001) and use of MT absolute
value encoder not permitted Reset reference measuring system
offset (C3012 = 0)
3500 ExtTripSet External fault has been activated. Fault has been set externally with
Ctrl1.TripReset. C4040: reset Ctrl1.TripReset = 0.
3501 InvTpProfN
o Invalid positioning profile number
with touch probe positioning Invalid positioning profile
number, e. g. for subsequent
block in touch probe positioning Select positioning profile
number < 15.
0503 InvalidFeed
b Impermissible feedback system
selection The selected feedback system
cannot be combined with the
profile function (e. g. position
feedback = encoder and
C3095 = 31). Correct the setting.
0504 InvalidOS Version of operating system is not
compatible. Application software requires
compact servo ECS with operating
system version
≥ 3.2.
Use suitable hardware and
operating system version
≥ 3.2.
x: 0 = TRIP, 1 = Message, 2 = Warning, 3 = FAIL−QSP