Lenze ECSCPxxx - Manual (Page 385)

Appendix
Code table
12
l
385 EDBCSXP064 EN 8.0
IMPORTANT Possible settings Code
Selection Lenze/
{Appl.} Designation No.
C0906 Analog input signals to MCTRL
Read only
1 MCTRL analog −199.99 {0.01 %} 199.99 Speed controller input
2 MCTRL analog Torque setpoint
3 MCTRL analog Lower torque limit
4 MCTRL analog Upper torque limit
5 MCTRL analog Limit of the position controller
6 MCTRL analog Speed for activating the torque
limitation
7 MCTRL analog Field weakening
8 MCTRL analog Integrator of the speed controller
9 MCTRL analog P adaptation of the position
controller
C0907 Digital input signals to MCTRL
Only display
1 MCTRL digital 0 1 Activating position controller
2 MCTRL digital Speed control or torque control
3 MCTRL digital Set quick stop (QSP)
4 MCTRL digital Loading integral−action
component of the speed
controller
C0908 MCTRL PosSet Set phase signal
1 revolution = 65536 increments
Only display
−2147483648 {1 inc} 2147483647
C0909 speed limit 1 Limitation of direction of
rotation for speed setpoint
1 −175 ... +175 %
2 0 ... +175 %
3 −175 ... 0 %
C0910 MCTRL TP2
delay
0 MCTRL dead time compensation
TP2 (X6/DI2)
−32767 {1 inc} 32767 1 inc º approx. 60 ms
C0911 MCTRL TP2
sel.
0 MCTRL touch probe signal source
0 Zero pulse of position encoder (C0490) X7/X8
1 Touch probe input TP2 X6/DI2
C0912 MCTRL TP2
Edge
0 MCTRL touch probe TP2 edge
(for touch probe via digital input
X6/DI2 (C0911 = 1))
0 Rising edge TP2
1 Falling edge TP2
2 Rising and falling edge TP2
3 Switched off
C1120 Sync mode 0 Sync signal source ^ 278
0 Off Off
1 CAN sync Sync connection via interface X4
(CAN) ^ 282
2 Terminal sync Sync connection via terminal
X6/DI1 ^ 283