Lenze ECSCPxxx - Manual (Page 244)

Commissioning
Operation with motors from other manufacturers
Entering motor data manually
6
l
244 EDBCSXP064 EN 8.0
6.29 Operation with motors from other manufacturers
6.29.1 Entering motor data manually
If you use motors of other manufacturers together with the ECS axis module, you have to
enter the motor data manually. The GDC includes the required codes in the parameter
menu under Motor/feedback systems
W W Motor.
ECSXA458
Fig. 6−62 GDC view: Manual setting of the motor data
I
Tip!
First, select a Lenze motor with similar motor data via the motor data input
assistant in the GDC (button with motor symbol). Then enter the exact
nameplate data via the corresponding codes.
Code Possible settings IMPORTANT
No. Designation Lenze/
{Appl.} Selection
[C0006] Op mode 1 Operating mode of the motor
control
l If the master pulse (via
MCTRL: C0911 = 0 or DfIn:
C0428 = 0) is used, the
voltage supply has to be
switched off and then on
again when the operating
mode is changed.
l Otherwise, the master pulses
will not be recognised.
1 Servo PM−SM Servo control of synchronous
motors
2 Servo ASM Servo control of asynchronous
motors