Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 104)

104 5. Configuring the Receiver Technical Reference Manual-4.0.0en
Log Moving Obs - Only available
when Log Static Obs = YES. Acti-
vates observation recording when the
receiver is in moving mode. The rate
is set in Obs Rate.
Static Init - Sets whether a Static
Initialization will be performed at the
beginning of a kinematic chain. When
using the SR510 set this option to
YES.
Log Auto Positions - Will automati-
cally log positions at a specified rate.
This is mostly used for real-time
operations.
See section 5.4 for
details.
Moving Ant Height - Sets the
Antenna Height when the receiver is
in moving mode. When a standard
System 500 pole setup is used, the
suggested default will be 2.00m.
Press CONT (F1) to continue to the
next screen.
Further options are available on this
screen in Advanced mode. See
section 5.2.1 for details. Occupation Settings
These settings control the way in
which points are occupied and
recorded.
OCUPY Mode - Sets the way in
which coordinates will be recorded for
a point.
Normal means that the observations
will be recorded when the STOP key
is pressed. A type of averaging is
performed on the measurements
observed over the time spent on the
point. This helps filter out effects of
slight movement. (E.g. trembling
hands).
Instantaneous means that a time tag
will be recorded when the OCUPY