Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 294)

294 11. Applications Technical Reference Manual-4.0.0en
Multiple point computation:
Press TRAV (F3) to start a sequential
traverse.
Easting, Northing and Height of the
first new point are displayed.
Press COORD (F2) to toggle
between coordinate types.
Press STAKE (F5) to switch to the
stakeout screen and use the
coordinates directly for stakeout.
Alternatively, enter a Point Id and
change the Height if neccessary.
Press STORE (F1) to store the point
and continue with the traverse.
The point stored is associated with a
traverse execution. Therefore, it is
suggested as next start point.
Enter the Bearing (Azimuth), the
optional Parallel Offset and the
Horizontal Distance. Instead of
entering these values manually you
may calculate them from two existing
points by pressing INV (F2).
Pressing TRAV (F3) displays the
results in the COGO\ Traverse
Results panel. There, press STORE
(F1).
This leads again to the COGO\
Traverse panel. Enter another
Bearing (Azimuth), the optional
Parallel Offset and the Horizontal
Distance. Press TRAV (F3) to con-
tinue the traverse or SIDE (F4) for a
single side shot.
In the COGO\ Traverse Results
panel, Easting, Northing and Height
of the side shot are displayed. Enter a
meaningful point ID and press
STORE (F1). Again, this leads to the
COGO\ Traverse panel.
To add another traverse point or side
shot follow the instructions above.
To finish the traverse enter the
Bearing (Azimuth), the optional
Parallel Offset and the Horizontal
Distance for the end point. Press
COMP (F1) followed by STORE (F1)
to return to the COGO\ Menu.