Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 145)

145
5. Configuring the Receiver Technical Reference Manual-4.0.0en
If Abs is chosen then the Avg. Limits
Pos and Avg. Limits Height are not
shown but the ABS (F6) key be-
comes available.
Press ABS (F6) to set the limits for
the absolute position difference in E,
N, H and X, Y, Z.
Stakeout
Stake from - Sets the source from
which target points will be taken. Job
means that the Rover will look for
target points from a Job that you use.
ASCII File means that you can stake
out using an ASCII file. The ASCII file
may be uploaded to the Receiver
using SKI Pro or by copying the ASCII
file onto a PC Card and using the
Transfer function. Alternatively use
the ASCII / GSI to Job converter and
use Stake from Job. See section 13.6
for more information.
Store → → → → → Job - Appears when ASCII
File is selected in Stake from. This
parameter takes the original ASCII
coordinate and stores it in the Job,
together with the staked point. This is
useful when comparing design points
to actually staked points.
Show Path - Will display a track on
the graphics screen of your previous
positions when set to Yes.
Def. Orient - Defines the default
orientation direction for stake out.
This is the direction from which
bearings or offsets will be taken. Note
that this is the default orientation. A
different orientation may always be
defined when running Stakeout.
The options are:
North - orient towards north.
Sun - the sun is used as the orienta-
tion direction. System 500 can calcu-
late the position of the sun for any
time and location on the earth’s
surface.
Press DEFLT (F5) to set the default
value of 0.07 m in all lines.
Press CONT (F1) to continue.