Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 118)

118 5. Configuring the Receiver Technical Reference Manual-4.0.0en
Setting up on a pillar will require that
you use the default pillar setup.
Advice on calculating Antenna
heights and offsets for Leica and non-
Leica Antennas is given in Chapter
2.15.
Use the EDIT (F3) key to edit the
highlighted Antenna configuration.
Note that factory default Antenna
configurations can only be viewed
and not edited.
Use the DEL (F4) key to delete an
Antenna configuration.
Use the DEFLT (F5) key to reveal
factory default Antenna configurations
with current Leica GPS Antennas.
This will then change to ALL.
Use ALL (F5) to reveal System 300
Antenna configurations also. You can
pick out the Antenna configurations
that you will use the most and delete
the rest.
All possible factory default Antenna
configurations may still be accessed
in the future by using the DEFLT and
ALL keys. Position
This screen defines the way in which
position is displayed.
Update Rate - Defines the rate at
which the position will be updated on
the display.
Coord Sys - You may also select a
coordinate system which will be used
to display the positions. The WGS84
coordinate system will always be
available. You may define other
coordinate systems in Applications
in Determine Coord System (see
section 11.1).