Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 226)

226 7. Measuring with System 500 Technical Reference Manual-4.0.0en
Grid Stake-Out can be used to stake out grids relative to a
defined reference line.
SE - Defined Reference Line
D - Distance to Station Begin
H - Horizontal Offset
V - Vertical Offset
I - Increment
The Reference Line is selected or defined. Define the
distance to the first station along the Reference Line, the
Horizontal and Vertical Offsets from the Reference Line.
Define the amount by which the Receiver should incre-
ment.
The first Target Point is the first point in the grid. Proceed
to this point and record it. After this point is recorded, the
next Target point will be shown. Carry on in this fashion
until you reach the end of the row.
You may then create a new row by redefining the Horizon-
tal Offset and switching the Increment to the negative
value. Follow this row back in the direction from which you
came, recording the grid points as you go. Alternatively,
you can redefine the horizontal offset and start the next
row in the same direction, next to the first grid point.
7.5.15 Grid Stake-Out - Procedure