Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 170)

170 7. Measuring with System 500 Technical Reference Manual-4.0.0en
It will be possible to add a code to a
point if a coding system has been
defined for use in the Configuration
Set.
System 500 supports two coding
methods; Thematical Coding and
Free Coding. The principles of both
methods of coding are explained in
Chapter 8.
Thematical Coding
The fields Point Code and Code
Name will be displayed as above.
Highlight the Point Code and either:
1. Use the left or right cursor keys to
cycle through the code list.
or
2. Press ENTER and select the code
from the list.
or
3. Type in the first few characters of
the code until the desired code is
displayed.
The Code Name will be displayed for
the Point Code that you have
chosen. Enter any attributes for the
code using the ATRIB (F4) key.
The code is stored along with the
Point Id information.
Free Coding
The Last Code and second last code
(2Last Code) that were used are
shown.
The CODE (F4) key will be available.
Press this key to access the codelist.
7.2.4 Adding a Code