Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 356)

356 Appendix H Technical Reference Manual-4.0.0en
Two different services are available.
RTCM corrections from the closest
reference can be received or your
own position can be sent to the
device which then receives correc-
tions based on a virtual reference
station.
In CONFIGURE\ Interfaces highlight
the Real-Time and press CTRL (F5).
Change Ref Net to Yes if corrections
for a virtual reference shall be used.
Press CONT (F1) to close the control
panel.
SAPOS is a reference station service
available for Germany.
To make use of this service there are
three different options:
1. SAPOS reference decoder box.
2. SMARTgate box.
3. Telemax Service.
Configuration
From CONFIGURE\ Interfaces
highlight Real-Time and press EDIT
(F3).
Press DEVCE (F5) to access the
device list. Select SAPOS-Box and
press CONT (F1) to confirm.
Select one of the following Data
Formats : RTCM 1,2, RTCM 18,19 or
RTCM 20,21.
SAPOS
Using a SAPOS decoder box