Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 219)

219 7. Measuring with System 500 Technical Reference Manual-4.0.0en
FILT (F6) allows to change the filter
settings for the currently selected Job.
More information about filter settings
can be found in section 11.3.
Press SHIFT to reveal REDRW (F4).
This redraws the map to the original
scale.
You may also scroll the map left/right,
up/down by using the cursor keys.
Auxiliary points are used as aids
when trying to find a stake out point.
Two auxiliary points are recorded to
form start and end points of a line.
The chainage and offset or distance
from each auxiliary point to the target
point is then displayed together with a
sketch.
The auxiliary points can have codes
assigned to them and can also be
downloaded into SKI Pro.
To start the auxiliary point routine,
press SHIFT and then AUXPT (F5).
Enter a point Id for Point A and record
the auxiliary point in exactly the same
way that you would record any other
point in real-time. Then carry out the
same operation for point B. After
pressing STORE (F1) the following
screen will appear.
7.5.12 Aux Pt
The line AB is displayed together with
the location of the target point.
Chg - The chainage along the line AB
to the target point.
Ofs - The Offset from line AB to the
target point. Negative value = left,
positive value = right.
Hgt A/Hgt B - Height difference
between auxiliary point A/B and the
target point.
Press DIST (F3) to display the
distance from each auxiliary point to
the target point instead of the
chainage and offset.
Press CONT (F1) to return to the
stake out screen.