Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 261)

261 10. Status Technical Reference Manual-4.0.0en
2. Real-Time Reference
Data Format - The data format being
sent.
Sats L1/L2 - The number of satellites
on L1/L2 being used in the
computation.
Last sent - The amount of time since
the last message was sent.
The DATA (F3) and REF (F6) keys
are available. The information
displayed there is exactly the same
as with a Real-Time Rover.
The Stop & Go Indicator gives infor-
mation regarding the amount of time
spent on a point and the amount of
time required at a point.
The information displayed differs,
depending on whether you are in
static or moving mode.
10.2 Stop and Go Indicator
Static Mode
Completed - A percentage value
indicating how much data is required
for successful processing (100%) and
how much has been collected. The
criteria used to display this value
depend on what has been set in the
Configuration Set. See explanation
below.
Time to Go - If set, a timer showing
how much time is left before you can
cease observations for this point.
Time at Pt - The amount of time
spent recording at the point.