Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 208)

208 7. Measuring with System 500 Technical Reference Manual-4.0.0en
7.5 Real-Time Rover, Staking Out
7.5.1 Entering Stakeout
Stake-Out is the staking out of
predetermined points. These points
may have been surveyed earlier and
uploaded through SKI Pro, may
already exist in a Job on the Receiver
or may have been uploaded in an
ASCII file.
System 500 offers the possibility to
stake out points, slopes and grids.
Stakeout must always be performed
in Real-Time, normally using a SR530
in order that centimeter level
accuracies can be achieved.
Therefore, a Real-Time Rover type
Configuration Set should always be
used.
Set up the equipment as described in
Chapter 2. Attach the Terminal.
Switch on. The Main Menu will be
displayed. The system will
automatically start searching for
satellites. If the Receiver is already
configured as a Real-Time Rover and
a signal is available from a reference
station, the Receiver will also
automatically start the ambiguity
resolution process. From the Main Menu, select Stake-
Out.
The following screen will then appear:
Config Set - The Configuration Set
used for the stakeout.
Stake Pts - The Job or ASCII file
used as the source for the points to
be staked. The source type can be
configured in
CONFIG\Survey\Stakeout.