Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 51)

51
2. Set-up and Connection Technical Reference Manual-4.0.0en
2.11 Equipment Setup - Real-Time Rover, All on Pole, TR500 and Sensor separated
Use
The TR500 is fixed to the pole grip with a holder. With
another metallic holder and a holder piece, the receiver is
fixed to the pole. The Radio Modem plus radio antenna
attaches to the Receiver. One connection is made from
the Receiver to the Antenna. Another connection is made
from the Receiver to the TR500. Recommended for short
periods of use, especially where there are many obstacles
(fences etc.).
Assumptions
1. GPS Antenna is mounted directly using screw fitting.
If using stub and GAD 31 adapter, procedures may
vary slightly.
2. Aluminium poles are used. You may replace them
with their Carbon Fiber equivalents without any
change to these instructions.