Leica Geosystems GPS System 500 - Technical Reference Manual User Manual
Page 108
Advertising
108
5. Configuring the Receiver
Technical Reference Manual-4.0.0en
You are completing a survey where you will require many different point IDs. Most point IDs will
need an incrementing number behind the text. The first points you measure will need the point ID
“Bolt ###”.
In CONFIG\ OCUPY Pts set up a point ID template
as shown here.
Note that the Id type is set to “Remain Running”.
Within the Survey panel, the first point will
automatically show the Point Id “Bolt 001” upon
pressing STORE, the next Point Id will automatically
show “Bolt 002”.
Working Example 1
Requirement -
Field Proc -
Settings -
Advertising