Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 262)

262 10. Status Technical Reference Manual-4.0.0en
Cycle Slips - The number of cycle
slips that have occurred on L1/L2
since recording commenced on the
current point.
GDOP - The current calculated value
for PDOP or GDOP.
Obs Rec Rate - The Observation
Recording Rate currently set.
Static Obs - The number of Static
Observations (epochs) recorded at
this point.
Completed Criteria - If no special
settings have been made in the
Configuration Set, the percentage is a
conservative estimate based on a 10-
15km baseline. This is also the
default setting for Real-Time
Reference Stations.
In a Post-Processed Survey, where
Auto Stop and/or STOP P-PRC have
been set, the value may be displayed
according to:
Time - A minimum time is specified.
Observations - A certain number of
observations have been specified.
Stop and Go Indicator - A baseline
length is selected and a percentage
calculated using the baseline length,
number of satellites and GDOP.
No. Sats - A length of time is
specified that varies with the number
of satellites available.
In a Real-Time Rover Survey, where
Auto Stop and/or STOP R-TME have
been set, the value may be displayed
according to:
Accuracy - when the specified
accuracy is reached, measurement
will stop. This is impossible to predict
in percentage terms and so the
default Stop and Go indicator (10-
15km) is displayed.
Positions - The number of real time
positions required on each point are
specified.
Stop and Go Indicator - A baseline
length is selected and a percentage
calculated using the baseline length,
number of satellites and GDOP.
No. Sats - A length of time is
specified that varies with the number
of satellites available.