Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 272)

272 10. Status Technical Reference Manual-4.0.0en
10.12 Interfaces Status
Gives an overview of all interfaces
and the port and device currently
assigned for that interface.
For example, a sensor is being used
as a real time rover with a Satelline
radio attached to port 1 and hidden
points are being collected using a
DISTO connected to port 2.
The NMEA output and the ASCII
Input are not currently configured.
For this type of operation, the
Interfaces panel would look as shown
above.
To get detailed information on the
status of single interfaces press the
IFACE (F3) button. Specific status
information is available for the
following interfaces.
Real-Time - Pressing IFACE (F3)
allows you to view the Real-Time
Input status. For details see chapter
10.1.
ASCII Input - Pressing IFACE (F3)
allows you to view the ASCII Input
status.
For each annotation you may either
view the given description or the last
received ASCII string specified by the
Message Id. Toggle between both
views by pressing DATA/DESCR (F3).
Event Input - Pressing IFACE (F3)
allows you to view the Time, Event
Count and Event Pulse Count for the
selected port(s).
For further details about Status
information for the different devices
please refer to Appendix H.