Leica Geosystems GPS System 500 - Technical Reference Manual User Manual
Page 346
346
Appendix H
Technical Reference Manual-4.0.0en
Select the Station to contact. The
phone Number of the Station (Refe-
rence) and the type of Protocol to be
used are displayed.
Accept Ref - Defines which reference
station to accept real-time data from.
Choose from the following:
Any Received means that the sensor
will accept data from any reference
station from which it receives data.
1st Received means that data will be
received and used from the first
reference station that is recognised
by the rover. If you wish to force the
system to try to establish a new
connection with a different reference
station press 1st (F6).
User defined enables you to define
which reference station data will be
received from according to its Ref
Stn Id.
Ref Stn Id - The Id of the Reference
Station to be used. Note that setting
Ref Stn Ids is only possible without a
survey or stakeout operation running.
NetDataRate - Some GSMs are
capable of automatic searching for
the network baud rate. In this case
Autobauding can be set. Otherwise,
one of the predefined network baud
rates must be selected.
ConnElement - Choose Non-Trans-
parent for a GSM working with RLP
(Radio Link Protocol) and Transpar-
ent for a GSM working without RLP.
Please refer to the GSM manual to
see if the GSM uses RLP. Before
RLP can be used with a GSM, it must
be support by the network. Check
with the network provider.
Search for the nearest GSM Refer-
ence Station to the current sensor
position by pressing NEAR (F2). The
current sensor position is the position
at the time when the NEAR key is
pressed. A GSM station is only
included in the search when Use
Coord in panel CONFIGURE\ GSM
Station is set to YES.
Once the nearest GSM Reference
Station has been found, the Station
field is updated accordingly.