Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 212)

212 7. Measuring with System 500 Technical Reference Manual-4.0.0en
The list of lines is displayed. If the list
is empty then there are no lines
defined! Use CONT (F1) to select the
highlighted line, New (F2) to define a
new line, EDIT (F3) to edit an existing
line and DEL-A (F4) to delete all the
lines in the list.
Lines are always stored in an ASCII
file, it is not possible to store lines in a
Job.
Lines are stored in local grid format. It
is however still possible to define a
line with WGS84 Geodetic or
Cartesian coordinates even when
only the WGS84 coordinate system is
being used. The sensor will
automatically use a standard UTM
projection to compute the necessary
grid coordinates.
The ASCII file is always defined as
STK_Line.txt and is stored on the PC
Card or Internal memory in the Data
sub-directory. You may write your own
line file on the PC and then transfer it
to the PC Card or internal memory.
The file format is given in Appendix D.
To define a new line, press NEW
(F2).
Input a Name for the Line. Select the
method to use to define the Line in
Type. You may select from:
Start+Endpoint
Start+Dst+Bg+%
Start+Dst+Bg+H/V
Start+Dst+Bg+V/H
Start+Dst+Bg+Hgt
S - Start - Start point
E - Endpoint - End point
D - Dst - Horizontal Distance
β - Brg - Bearing
H - H - Horizontal component
V - V - Vertical component
h - Hgt - Height difference
% = V/H Ч 100