Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 186)

186 7. Measuring with System 500 Technical Reference Manual-4.0.0en
The Accuracy Status Icon will be
displayed as follows:
Additionally, the Coordinate Quality
should
show between 0.01 and 0.05.
To record a point, place and level the
pole. Input information such as Point
Id and Code (if required). If working in
Advanced mode, use the ADD (F5)
key to add point annotations. Press
the OCUPY (F1) key.
Then, according to what has been set
in Occupation Settings, press STOP
(F1) and STORE (F1).
Measuring procedure without
starting time
Switch on the instrument. Select
Survey. Select a Real-Time Rover
Configuration Set in which auto
occupy has not been set to Timed in
the Occupation Settings.
During this time, the unit should
acquire satellites and should pick up
the signal from the Reference.
When enough of the same satellites
are tracked simultaneously at the
Rover and Reference and the signal
from the Reference is received, the
Receiver will automatically start the
ambiguity resolution process.
7.4.6 Measurement Procedure
Note that if code only measurements
are being used, the ambiguity
resolution process is not required and
therefore will not start.
The ambiguity resolution process will
run. When the ambiguities are
resolved, the baseline from the
Reference to the Rover is calculated
to between 1-5cm.