Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 131)

131
5. Configuring the Receiver Technical Reference Manual-4.0.0en
Coding
If you wish to select a coding system
press ENTER and choose from
Thematical or Free coding. Complete
descriptions of the coding systems
used by System 500 are given in
Chapter 8.
Press CODES (F3) to review the
codes in the chosen codelist. You
may also edit the codelist here.
Real-Time Use the right or left cursor keys to
select a port for transmission of real-
time data. The device that is currently
assigned to this port will be displayed.
Ref Sensor - Select the Receiver
type used at the Reference Station. If
this is not a Leica Receiver select
Unknown.
Ref Antenna - select the Antenna
used at the reference station. All
Antennas in the current antenna list
are available. If you do not know
which Antenna is being used at the
reference or an Antenna is being
used which is not in the list, select
Unknown.
If the reference data is
corrected by absolute antenna cali-
bration values and you want to use
Leica standard antenna models on
the rover side, select
ADVNULLANTENNA.
Use Phase - Set to NO if only a code
solution is required.
R-Time Data - defines the operation
mode of the Receiver. Select Rover
to receive real-time data.
Data Format - Defines the format
used to broadcast the real-time data.
Port - defines the port to where the
Real-Time receive device will be
connected. Normally this will be a
radio modem or GSM phone. When
the radio modem is a Satelline 1AS/
2ASx/2ASxE, Pacific Crest
RFM96(W) or GSM phone it will be
mounted in a housing and attached to
either Port 3 or Port 1. You may also
attach a radio modem or phone
without a housing via a cable to any
port.