Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 265)

265 10. Status Technical Reference Manual-4.0.0en
Grade <1:> - Grade between the first
point and the current rover position.
grade = 1 : slope =
∆
V :
∆
H
positive for cut slopes
negative for fill slopes
Hgt Diff - Orthometric height differ-
ence between the origin point and the
current rover position. If the
orthometric heights are unavailabel,
the height difference refers to the
local ellipsoid. Should this not be
available either, the WGS84 ellipsoi-
dal is used instead.
Horz Dist - Horizontal grid distance
between the origin point and the
current rover position. If local grid
coordinates are unavailable,
thehorizontal distance refers to the
local ellipsoid. Should this not be
available wither, the WGS84 ellipsoid
is used instead.
Slope Dist - Slope distance between
the origin point and the current rover
position in local grid. If local grid is
unavailable, local ellipsoidal coordi-
nates are used instead. Should those
not be available either, the WGS84
ellipsoidal coordinates are used.
∆ H
fill slope
∆
V
−−−−− ∆ V : ∆ H +++++ ∆ V : ∆ H
∆ H
cut slope
∆ V
Grade <%> - Grade between the first
point and the current rover position in
percent.
Bearing - Bearing between the origin
point and the current rover position.
Displayed if the method is Known
Point or Last Point.