Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 168)

168 7. Measuring with System 500 Technical Reference Manual-4.0.0en
The Main Survey screen appears.
From here you can add Point Id,
Code, Antenna Height and observe
the DOP.
If configured, you will also be able to
enter a start time for the point
occupation.
As soon as the receiver has enough
information, the DOP will be
displayed.
The PP_KIS default post-processed
kinematic configuration set is defined
such that you must perform a static
initialization.
This will always be the case when
using a SR510. SR520 and SR530
users may set the static initialization
parameter to NO and perform
initialization on the fly.
Further details about this procedure
are given in the sections that follow.
7.2.2 Adding the Point Id 7.2.1 Overview of Procedure
The Point Id is an identifier for a
particular point. It also collates all
measurements made on that point
and all other associated data such as
codes, point annotations and
meteorological data.
If a point Id template has been
configured in the Configuration Set, a
Point Id will be suggested. You can
overwrite this with a different Id if
required.
If no point Id is suggested then enter
a point Id. By default if the point Id
contains any numerical values, these
will be incremented by 1.