Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 259)

259 10. Status Technical Reference Manual-4.0.0en
10. Status
The Status of all Receiver functions
can be accessed through the
STATUS key at any time.
Status is divided into 4 main sub
menus.
1 Survey - Status of survey related
functions.
2 Logs - Logfiles of what has been
recorded.
3 General - Status of hardware and
firmware.
4 Interfaces - Status of the
interfaces, ports and external
devices.
10.1 Real-Time Input Status
Real-Time Status is available when a
Real-Time reference or Real-Time
rover is being used. The information
available differs with the operation
mode.
The panels below describe what
would be seen when an RTK
reference or rover is being used with
Leica data format. Different data
would be seen if RTCM corrections
were being used or code only data
was being transmitted and received.
1. Real-Time Rover
Data Format - The data format being
received.
Sats L1/L2 - The number of satellites
on L1/L2 being used in the
computation.
Last recvd - The amount of time
since the last message was received
from the reference station.
% recvd - The Receiver compares
the amount of data received through
the GPS Antenna with the amount
received from the reference station
and displays this as a percentage.