Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 56)

56 2. Set-up and Connection Technical Reference Manual-4.0.0en
How to set up the equipment
1. Insert the PC Card into the
Receiver and plug in the
GEB121 batteries.
2. Place the Receiver front panel
up in the Minipack with the
batteries facing outwards.
Fasten the strap around the
Receiver
3. Connect the RTB/GPS Antenna
to the Receiver using the An-
tenna cables. Connect the cable
to the RTB/RTS module and
route the cable around the
bottom of the Receiver and up to
to the GPS antenna. Refer to the
diagram.
4. Connect the TR500 to the port
labelled “Terminal” on the
Receiver using the 1.8m cable.
Pass it through the opening in
the bottom of the Minipack flap,
down through a cable brake and
then plug into the Receiver.
Refer to the diagram.
5. Connect the RTB/RTS module to
the Receiver GPS antenna port
using the 30 cm antenna cable.
6. Switch on the system using the
ON/OFF button on the Receiver.
To GPS/RTB (or RTS) antenna
From RTS/RTB module
to GPS antenna port
To Terminal