Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 123)

123
5. Configuring the Receiver Technical Reference Manual-4.0.0en
Logging
If required, you may log the raw
observations. This may be used if
there are problems with the data
reception at the Rover and a Real-
Time position could not be calculated.
The observation data can be post-
processed when back in the office to
fill in any gaps in the Real-Time
positions. Of course, observations
must be logged at the Rover also.
Log Static Obs - Switches logging on
or off when the Receiver is in Static
mode.
Obs Rate - The rate at which obser-
vations will be logged.
For Real-Time Reference stations the
rate should be set the same as the
Position Update Rate at the Rover.
This will normally be between 0.1-2s.
Press CONT (F1) to continue to the
next screen.
Further options are available on this
screen in Advanced mode. See
section 5.3.1 for details.
Press CONT (F1) to complete the
configuration.
Note that a different port must be
selected to that used for the Real-
Time 1 interface.
Use SHIFT R-T 1 (F2) to accept the
configuration settings and return to
Real-Time 1.
Use CONT (F1) to return to the
CONFIGURE\ Interface panel.
The Port/ Device configured for both
real-time interfaces is now visible.