Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 98)

98 5. Configuring the Receiver Technical Reference Manual-4.0.0en
Working Example
Application - Post Processed Rapid Static Observation Recording
Technique - Rapid Static
Requirement - You wish to view the Stop and Go Indicator on the Main
Survey screen but do not want to automatically stop the survey.
Settings -
Other Settings - Use P-PRC (F5) to set the Baseline Length.
Field Procedure - After pressing OCUPY the time or epoch counter will
start. The Stop and Go Indicator percentage value will be shown in brackets
next to this. It will run until STOP is pressed. The observations will not stop
being recorded at 100% automatically. Further information regarding the
STOP & GO indicator is available in STATUS\SURVEY\STOP&GO
Indicator.
Id Templates
Id Templates are not normally of use
for Static, Rapid Static or Kinematic
Reference Stations and should be set
to No Template Used.
However, should you wish to use
them, you will find you may also
configure Id Templates for Auxiliary
Points in exactly the same way as for
normal points.