Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 148)

148 5. Configuring the Receiver Technical Reference Manual-4.0.0en
The Advanced Mode contains extra
configurable parameters that may be
required for certain specialized
applications.
Select Advanced in
CONFIGURE\Operation Mode.
Only the screens that differ from
those seen in Standard Mode are
described here.
Position
In addition to the functionality given in
Standard mode, details about the
chosen coordinate system are given.
Residuals - The method by which
residuals will be distributed
throughout the transformation area is
displayed.
Transform - The name of the
transformation set used is displayed.
Ellipsoid - The name of the local
ellipsoid is displayed.
Projection -The name of the
projection used is displayed.
Geoid Model - The name of the
geoid model used is displayed.
CSCS Model - The name of the
CSCS model used is displayed.
Note that the details that are
displayed depend upon the type of
transformation used. Certain types of
transformation do not use all of the
described parameters to calculate
local coordinates.
Pressing Shift followed by FILT (F4)
will access the panel CONFIGURE\
Filter.
Height Smoothing - Enables you to
activate or deactivate the height
smoothing filter. With YES, smoothing
is applied to all heights measured in
the WGS84 or in a local coordinate
system or output via NMEA. The filter
defaults are best suited for high
dynamic variations in height up to
1 m/s as carried out by graders.
5.4.1 Advanced Operation Mode for Real Time Rover