Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 174)

174 7. Measuring with System 500 Technical Reference Manual-4.0.0en
7.2.7 Using the AUTO key 7.2.8 Using the ADD key
If Log Auto Positions is set to YES
in the CONFIGURE\ Logging screen
the Auto (F3) key is available in the
main Survey screen.
Auto (F3) can be used to switch to
the mode for measuring Auto-
Positions in the Auto-Pos panel.
This functionality is mostly used in
Real-Time Rover operations. For
details on measuring Auto-Positions
refer to chapter 7.4.7 Using the
AUTO key in Real-Time Rover
measurement procedures.
When the Advanced Mode is
selected, the ADD (F5) key is
available.
This key can be used to add Point
Annotations, Meteorological Data and
Hidden Points.
Press ADD (F5).
Once the point is stored, again the
OCUPY (F1) key becomes available
and the start time line is shown with
the current time and the seconds
rounded to zero.
To start a new occupation - either the
first point recording after initialization
or a subsequent point recording -
enter the next start time. Then press
OCUPY (F1).