Leica Geosystems GPS System 500 - Technical Reference Manual User Manual
Page 47
47
2. Set-up and Connection
Technical Reference Manual-4.0.0en
The Next Steps
If the Receiver has been pre-pro-
grammed and the TR500 is being
used, further guidance is available in
Chapter 7.
If the Receiver requires programming
with the TR500, further guidance is
available in Chapter 5.
When using the upper pole
halves with stub, ensure that
the Antenna and GAD31 screw/stub
adapter slide down the full length of
the stub before tightening the locking
ring. An incorrectly mounted Antenna
will have a direct effect on your
results.
Advice on using the Minipack
is given in Section 2.14.
Ensure a dry plastic weather
protection cap is fitted to the
socket on the TR500 that is not
connected to the sensor.
If moisture or water should
appear in the socket that is
not used on the TR500, allow the
socket and plastic weather protection
cap to dry naturally.