Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 50)

50 2. Set-up and Connection Technical Reference Manual-4.0.0en
How to set up the equipment
Follow steps 1-6 described in section
2.5.
7. Clip the Antenna Arm to the
GPS Antenna. Screw the Radio
Antenna onto the Arm.
8. Attach the Radio Modem in its
housing to the GPS Receiver.
9. Connect the Radio Antenna to
the Radio Modem using a 1.2m
Antenna Cable.
10. Switch the System ON using the
ON/OFF key on the Terminal.
The Next Steps
If the Receiver has been pre-pro-
grammed and the TR500 is being
used, further guidance is available in
Chapter 7.
If the Receiver requires programming
with the TR500, further guidance is
available in Chapter 5.
When using the upper pole
halves with stub, ensure that
the Antenna and GAD31 screw/stub
adapter slide down the full length of
the stub before tightening the locking
ring. An incorrectly mounted Antenna
will have a direct effect on your
results.
The Radio Antenna may also
be connected directly to the
Radio Housing. Note however that
range and quality of signal received
may be affected.