Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 350)

350 Appendix H Technical Reference Manual-4.0.0en
Modem
A Modem device is normally used to
communicate with the Sensor e.g. to
download data or to transmit NMEA
messages etc.
The following modem communication
settings are as standard included with
System 500:
U.S. Robotics 56K
Sprint PCS Motorola Timeport P8167
If you are using a third party
modem make sure it sup-
ports AT command lan-
guage.
Configuring the Modem
From CONFIGURE\ Interfaces
highlight the interface (e.g. Prim.
Remote) you want to use with a
modem and press EDIT (F3).
Press DEVCE (F5) to access the
device list.
Highlight Modem from the list and
press NEW (F2). Enter a name (E.g.
ModemXY) and enter the applicable
device parameters.
The port settings are the parameters
used for the communication between
the Sensor and the modem. If re-
quired edit them to suit the modem.