Leica Geosystems GPS System 500 - Technical Reference Manual User Manual
Page 207
207
7. Measuring with System 500
Technical Reference Manual-4.0.0en
Then one of three scenarios can
ensue:
1. Contact with the Reference is
reestablished within the
minimum logging time specified
in the Configuration Set. Logging
will carry on for this minimum
time and then stop.
2. Contact with the Reference is
reestablished after the minimum
logging time specified in the
Configuration Set. Logging will
stop.
3. Contact with the Reference is
not reestablished. Logging will
continue until the survey is
ended or contact with the
Reference Station is
reestablished.
When using Post-Processing Infill it is
useful to note the following points:
1. The Reference Station must
also be logging data at the same
rate or higher than the Rover.
2. The data is logged as a
kinematic chain. Distinct points
within the chain may be logged
as in a post-processed
kinematic survey.
3. The data has to be downloaded
and processed using SKI-Pro.
All of the data (Real-Time points
and raw data), will be imported
into the same SKI-Pro Project.