Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 162)

162 7. Measuring with System 500 Technical Reference Manual-4.0.0en
2. Press ENTER and select the code
from the list.
or
3. Type in the first few characters of
the code until the desired code is
displayed.
The Code Name will be displayed for
the Point Code that you have cho-
sen. Enter any attributes for the code
using the ATRIB (F4) key.
The code is stored along with the
Point Id information.
Free Coding
The Last Code and second last code
(2Last Code) that were used are
shown.
The CODE (F4) key will be available.
Press this key to access the codelist.
To select the code:
1. Use the left or right cursor keys to
cycle through the code list.
or
2. Press ENTER and select the code
from the list.
or
3. Type in the first few characters of
the code until the desired code is
displayed.
An asterisk next to a code indicates
that it has attributes.
Press CONT (F1) to select the code.
Further information about Coding
Systems is available in Section 8.