Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 384)

384 Appendix K Technical Reference Manual-4.0.0en
The CONFIG Key
Described below are the changes that
apply to the use of the CONFIG key
in the GS50 and GS50+.
For example, the main configuration
menu uses the wording GIS Data
Collection instead of Survey.
Configuration: Satellite
The Satellite configuration option
uses an additional choice for the track
mode. The default choice is Max.
Accuracy, the additional choice on
GS50 / GS50+ is MaxTrak™.
With the MaxTrak™ option, satellite
tracking is much more stable under
poor GPS conditions. For long-time
static measurements under good
conditions, the accuracy of the default
Max. Accuracy setting is higher than
with the MaxTrak™ setting.
The MaxTrak™ should be used when
no GPS measurement would normally
be possible.
Track Mode as well as the SV Health
configurations options are visible in
Advanced mode only.
LossOf Lock - When losing all
satellite signals for example due to
satellite shading caused by tall
buildings, trees, etc. a message
“Complete loss of lock” appears. The
sensor may be configured to beep
with this loss of lock message or not.