Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 90)

90 5. Configuring the Receiver Technical Reference Manual-4.0.0en
Note that factory default antenna
setups contain an elevation depen-
dent correction model. This is not
seen by the user. When setting up
your own configuration with the
Receiver, this model is not taken over.
This model is required for real-time
rover operations. If you need to input
your own antenna setup and it re-
quires an antenna correction model,
use SKI Pro to configure the antenna
setup and transfer it to the Receiver.
Advice on calculating Antenna
heights and offsets for Leica and non-
Leica Antennas is given in Chapter
2.15.
Use the EDIT (F3) key to edit the
highlighted Antenna configuration.
Note that factory default Antenna
configurations can only be viewed
and not edited.
Use the DEL (F4) key to delete an
Antenna configuration.
Use the DEFLT (F5) key to reveal
factory default Antenna configurations
with current System 500 GPS Anten-
nas. This will then change to ALL.
Use ALL (F5) to reveal System 300
Antenna configurations also. You can
pick out the Antenna configurations
that you will use the most and delete
the rest. All possible factory default
Antenna configurations may still be
accessed in the future by using the
DEFLT and ALL keys. Position
This screen defines the way in which
position is displayed. These settings
are mostly used for Real-Time Rover
setups.
Update Rate - Defines the rate at
which the position will be updated on
the display.
Coord Sys - You may select a
coordinate system which will be used
to display the positions. The WGS84
coordinate system will always be
available and should be sufficient for
Static/Rapid Static work. You may
determine other coordinate systems
in SKI Pro and upload them or you
may determine other coordinate