Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 137)

137
5. Configuring the Receiver Technical Reference Manual-4.0.0en
Instantaneous means that a time tag
will be recorded when the OCUPY
key is pressed. A coordinate will be
interpolated between the positions at
the neighbouring two epochs.
More details about Normal and
Instantaneous occupy modes are
given in section 5.2.
Auto Store - Allows you to automati-
cally store a point after the STOP key
has been pressed.
Further options are available on this
screen in Advanced mode. See
section 5.4.1 for details.
The logging of Auto-Positions may
also be configured from inside the
AUTO-POS panel. See chapter 7.4.7
Using the AUTO key for more
information.
When Distance is selected, a posi-
tion will be recorded every time the
distance from the previously recorded
point matches the value set in the
Log Every line. You can also define
the Quality Info recorded with the
point in the same way as when Time
is selected.
When Height is selected, a position
will be recorded every time the height
difference from the previously re-
corded point matches the value set in
the Log Every line. You can also
define the Quality Info recorded with
the point in the same way as when
Time is selected.
Press CONT (F1) to return to the
CONFIGURE\Logging screen.
Press CONT (F1) to continue to the
next screen.
Occupation Settings
OCUPY Mode - Sets the way in
which coordinates will be recorded for
a point.
Normal means that the coordinates
will be recorded using an average of
the positions calculated between
pressing OCUPY and STOP. This
helps filter out effects of slight move-
ment. (E.g. trembling hands).