Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 135)

135
5. Configuring the Receiver Technical Reference Manual-4.0.0en
Log Pos by - Defines the criteria by
which an automatic position will be
logged.
When Time is selected, the Position
Rate defined in Configure\Position is
displayed. This may be multiplied by
the Log Factor to give a position
logging rate displayed in the Log
Every line.
Store Pt DB – If this parameter is set
to YES the Auto-Points will be stored
to the GeoDB. This is the setting that
is needed if it is intended to store
codes with Auto-Points. Auto-Points
stored to the GeoDB may additionally
be viewed and edited in the Point
Management, they may be output
with an .FRT file, they may be staked
out or viewed in the Graph panel.
Log Auto Positions - Will automati-
cally log positions at a specified rate.
Moving Ant Height - Sets the
Antenna Height when the receiver is
in moving mode. When a standard
System 500 pole setup is used, the
suggested default will be 2.00m.
Press CONT (F1) to continue to the
next screen.
Further options are available on this
screen in Advanced mode. See
section 5.4.1 for details.
When Log Auto Positions is set to
YES, the POS (F3) key becomes
available. Use this key to define the
criteria for automatic position record-
ing.
Note, if it is chosen to store Auto-
Points to the GeoDB, the maximum
recording rate is 1Hz.
Start Mode – You may select from
either Immediate or Controlled. If
you select Immediate the system will
automatically start with logging Auto-
Points as soon as you start the
survey. If you select Controlled you
will decide when you start the logging
of Auto-Points. Press the AUTO key
in the main Survey panel to enter the
mode for measuring Auto-Positions.
In the AUTO-POS panel the START
(F6) key will be available to you.