Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 122)

122 5. Configuring the Receiver Technical Reference Manual-4.0.0en
Pressing the DEVCE (F5) key lets
you configure and assign a device to
the selected port.
Select the device you wish to assign
to the port. If no default devices are
displayed press DEFLT (F5) to reveal
them. Default devices have an
asterisk before the device name.
Select a device from the list. To view
the configuration of your chosen
device, press EDIT (F3). If the device
you wish to use requires a different
configuration, select Unknown Radio
and press NEW (F2) and enter the
Name and Port Settings for the
device.
A complete list of all available devices
is given in Appendix H.
stations simultaneously, broadcasting
on different frequency channels and
use frequency switching at the rover.
or
2. The Reference is being moved
from one point to another.
If it is required to configure the sec-
ond real-time interface press SHIFT
R-T 2 (F2) in the CONFIGURE\ Real-
Time 1 panel.
Configure the parameters for the
Real-Time 2 interface as described
above. The second Real-Time 2
interface is completely independent to
the Real-Time 1 interface so that a
different Data Format and Rate may
be selected.
Press CONT (F1) to return to CON-
FIGURE\ Real-Time1.
Pressing REF (F6) enables you to
configure further options concerning
the broadcast messages from the
reference station.
You may define a number for the
reference station ID, select a carriage
return at the end of each message
and, if RTCM format has been
selected, choose the RTCM Version
to output. Note that the Reference
and Rover must use the same RTCM
version.
You will need to define a Ref Stn Id if:
1. You intend to work with 2 reference