Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 190)

190 7. Measuring with System 500 Technical Reference Manual-4.0.0en
AutoPt Id – If no Auto Log Pos Point
Id template has been chosen the
default template Time and Date will
be used. Alternatively a Point Id
template may be defined (see chapter
5.4. Configuring the Receiver for
Real-Time Rover Operations).
Mov Ant Hgt – Sets the Antenna
Height when the receiver is in moving
mode. When a standard System 500
pole setup is used, the suggested
default will be 2.00m.
Quality – Displays the quality of your
current position.
If a coding system has been defined
for use in the Configuration Set it will
be possible to add a code to the auto-
logged point. This may be either a
thematical code or a free code.
If Log Auto Positions is set to YES
in the CONFIGURE\ Logging screen
the Auto (F3) key is available in the
main Survey screen.
Auto (F3) can be used to switch to
the mode for measuring Auto-
Positions in the Auto-Pos panel.
The absolute differences for Easting,
Northing and Height can only be
displayed if the survey is carried out
in a local coordinate system.
An asterisk identifies those which
exceed the threshold settings.
CONT (F1) returns you to the survey
screen.
7.4.7 Using the AUTO key