Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 87)

87
5. Configuring the Receiver Technical Reference Manual-4.0.0en
The following screen will appear the
first time you switch on.
The most frequently used functions
are displayed. Use SHOW/HIDE (F4)
to reveal/hide all of the functions.
This chapter covers configuration
using the sequential configuration
(Configure) from the Main Menu.
Details about configuration using the
CONFIG key can be found in Chapter
9.
Select Configure from the Main
Menu. Press CONT (F1).
The following screen will appear:
You can select a Configuration Set by
moving up and down the list and
pressing CONT (F1) or entering the
name of the Configuration Set. Press
EDIT (F3) to edit it.
Changes in
default Configuration Sets are only
temporary until the sensor is turned
of. Permanent changes, require the
creation of a new Configuration Set.
To enter a new Configuration Set
press NEW (F2).
To delete a Configuration Set press
DEL (F4). You will be asked for
confirmation before the Configuration
Set is deleted.
Pressing INFO (F5) toggles between
the date of creation, creator and
description of the Configuration Sets.
Entering a new Configuration Set
After NEW (F2) has been selected,
the following screen will appear.
Enter the Name and, if required a
Description and Creator. Press the
ENTER key after each entry. Press
CONT (F1) when you are finished.
If you create a new Configuration Set
a copy of the highlighted
Configuration Set will be created.