Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 60)

60 2. Set-up and Connection Technical Reference Manual-4.0.0en
How to set up the equipment
1. Set up the tripod.
2. Screw the Base for the
Telescopic Rod onto the Tripod.
Push the Telescopic Rod into
the Base.
3. Screw the Short Antenna Arm
onto the Telescopic Rod. Screw
the Radio Antenna onto the Arm.
4. Connect the Radio Modem to
the Repeater Box. Attach the
Repeater Box to the tripod.
5. Connect the Radio Modem to the
Radio Antenna using the 2.8m
Antenna Cable.
6. Connect the Repeater Box to the
GEB71 battery.
The Next Steps
As soon as the Repeater Box is
connected to the battery, it is ready to
receive and broadcast data.
Start surveying or a staking-out with
the rover. Further guidance is
available in Chapter 7.4 and 7.5.