Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 109)

109
5. Configuring the Receiver Technical Reference Manual-4.0.0en
Working Example 1 (cont)
You now wish to survey points with the Id
“Road####” starting with Id “Road0723”. Enter this
point Id into Survey panel. The next point Id will
automatically be “Road0724”.
You now wish to survey one individual point and give
it the point ID “BM98”. In the Survey panel, press
SHIFT and then INDIV (F5) and enter this point Id.
Survey this point and upon pressing STORE, the
next point Id will revert back to “Road0724”.
Field Proc
(cont) -
Note: Should you wish to store any new point Id as a template into the “library” then access the
CONFIGURE\ ID Templates panel (CONFIG, 1 Survey, 5 Point Id Templates) and then press
CONT (F1). The point Id currently in use is now stored as a template.