Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 136)

136 5. Configuring the Receiver Technical Reference Manual-4.0.0en
Quality Info - Defines which quality
information should be recorded with
the position. You may select from the
Full covariance information or just
the coordinate quality (CQ only).
Use Beep - If YES, the terminal will
beep when an automatic position is
logged.
Monitor CQ - If YES, the CQ of the
automatic position will be monitored
and the point will only be recorded if
less than the specified quality. When
YES is chosen an additional line
appears below Monitor CQ to enter
the specified quality.
Use Annot - This line is visible, if
Store Pt DB is set to YES. If YES,
point annotations will be stored in the
GeoDB with each auto logged point,
too. Point Annotations may be used
as an electronic notepad where
events, notes etc. may be written.
They are then taken with the point Id
information into SKI-Pro.
Point annotations for auto logged
points are independant from point
annotations for manually occupied
points.
You may type in 4 notes with up to 26
characters in each note.
Press CLEAR (F6) to delete the
content of all input fields and CONT
(F1) to leave the panel.
After doing so and reentering the
panel SURVEY\Point Annotations
with ANNOT (F5), the keys LAST
(F3) and LAST# (F5) will be active. #
stands for the numbers 1 to 4 of the
point annotations and changes with
the cursor position. LAST (F3)
reactivates all previous four point
annotations. LAST# (F5) only
reactivates the previous annotation of
the last line.
Annotations are ignored when
entering point annotations first and
then changing USE ANNOT to NO.
With setting USE ANNOT to YES
again, the last annotations are
remembered.
Point Annotations are remembered
until the system is turned off.
Point annotations can be viewed in
Point Management. See chapter 11.3.
An ANNOT (F5) key becomes
available.