Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 28)

28 2. Set-up and Connection Technical Reference Manual-4.0.0en
Use
Post Processed Kinematic Rover.
The Receiver is placed in the Minipack. Connections are
made to the Antenna and TR500. Recommended for
extended periods of use in the field.
Assumptions
1. GPS Antenna is mounted directly using screw fitting.
If using stub and GAD 31 adapter, procedures may
vary slightly.
2. Aluminium poles are used. You may replace them
with their Carbon Fiber equivalents without any
change to these instructions.
2.4 Equipment Setup - Post Processed Kinematic, Minipack and Pole